This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
block:geolyzer [2014/07/10 00:57] sangar created |
block:geolyzer [2015/03/24 04:29] fallen_dead [Geolyzer] Added tips. |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | {{:blocks:geolyzer.png?nolink&200|}} | + | Geolyzer |
| + | ======= | ||
| + | {{:blocks:geolyzer.png?nolink&128|}} | ||
| This block allows scanning its surroundings for the hardness of blocks. It's vertical range is 32 blocks up and down, so a column of height 64 in total. It operates in "columns", e.g. when scanning at the relative coordinates (0, 0) it will scan the blocks 32 below and above (and including) the geolyzer block. | This block allows scanning its surroundings for the hardness of blocks. It's vertical range is 32 blocks up and down, so a column of height 64 in total. It operates in "columns", e.g. when scanning at the relative coordinates (0, 0) it will scan the blocks 32 below and above (and including) the geolyzer block. | ||
| Line 7: | Line 9: | ||
| *Since version 1.3.* | *Since version 1.3.* | ||
| + | Tips | ||
| + | ======= | ||
| + | Even though the Geolyzer uses relative coordinates, it is still possible to get global coordinates of scans by using a bit of simple math. | ||
| + | |||
| + | The "noise" added to scanned areas is increased based off of distance from device. | ||
| + | It is theoretically possible to eliminate this noise by scanning repeatedly and finding an average. (Unconfirmed, needs further testing.) | ||
| + | |||
| + | |||
| + | Contents | ||
| + | ----------- | ||
| + | {{page>block:contents&noheader&noeditbutton&nouser&nofooter}} | ||